Cornelius CH Series Manuel de l'opérateur télécharger pdf (Page 9)

620914301

Condenser

On air--cooled Chillers, the CONDENSER FINS should be cleaned by blowing compressed air through the con-

denser from the fan side. Dirt and debris accumulate on the condenser fins over time, and this build up can se-

verely reduce the performance of the Chiller. Cleaning of the CONDENSER COIL FINS should be done

approximately every three months, depending upon cleanliness of your application.

Fan Motor

On air--cooled Chillers, the condenser FAN MOTOR should be lubricated every 6 months with a few drops of

SAE 10 oil.

Pump Motor

The PUMP MOTOR should be lubricated with thirty drops of SAE 20 oil once a year.

Circulation System

The CIRCULATION SYSTEM should be drained and flushed periodically to avoid build up and a possible flow

restriction caused by contaminants.

Filters/Strainers

The STRAINER at the Chiller inlet should be removed and cleaned monthly.

The “Y” STRAINER, located inside the unit at the inlet of the pump, should be cleaned periodically depending on

applications. If a reduction in flow or cavitation of the pump occurs, remove the strainer, flush it out with water,

then replace.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Pas de commentaire

Cornelius CH Series Manuel de l'opérateur Page 9