Cornelius SID650W/80-BC Manuel de l'opérateur télécharger pdf (Page 5)

291704

INSTALLATION INSTRUCTIONS

UNPACKING INSTRUCTIONS

1. With the unit upright, carefully remove the shipping crate. Inspect for shipping damage and report any such

damage t o the shipper im mediately.

2. Unlock and open the hinged service door on the upper lef t side panel.

3. Remove shipping tape f rom the ice drop cover, storage hopper cover, water float valve and agitator in the

storage hopper.

4. Remove shipping tape f rom air inlet filter and sink grill.

INSTALLATION INS TRUCTIONS

NOTE: A Cornelius Model XXXX water filter(or equal) ice maker quality water treatment unit MUST BE

INSTALLED in the water supply line to the ice maker. Failure to do so may result in poor

quality ice, low production output, and may cause premature failure of the i ce maker

evaporator and void the extended evaporator warranty.

This ice maker is provided with a stainless steel

evaporator designed to last the life of the

product. But, some of the chemicals in treated and untreated water, specifically chlorine and

sulphur (sulphide), have the ability to attack stainless steel and cause premature failure. An

initial investment in proper water treatment will pay for itself in increased production, quality

and long life of the product.

Location

Locate the ice maker/dispenser indoors in a well-ventilated area. Avoid exposure to direct sunlight and/or

heat caused by radiation.

Ambient room temperature must be in the range of 60° to 90°F. Do not install unit in a n enclosed area

where heat build up could be a problem. For proper airf low for the refrigeration system, allow a 6

 clear-

ance at the back of the unit

anda12 clearance at the right side panel.

Consult Figure 1 f or utility connection location.

Consult Figure 2 f or dimensions for mounting the unit to t he counter with the hardware provided. Note that

the unit must be level for proper operation.

The unit must be sealed

to t he counter. The m ounting template drawing (Figure 2) indicated t he openings

which must be cut in the counter. Locate the desired position for t he unit, t hen mark the outline dimensions

and cut-out locations using the t emplate drawing. Cut openings in counter.

Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equal) approximate-

ly 1/4

inside of the unit outline dim ensions and around all openings. Then position the unit on the counter

within the outline dim ensions. All excess sealant must be wiped away.

Plumbing

Connect the ice maker to a cold, potable water source suitable f or drinking. Do not install the unit on a

water soft ener line. It is recommended t hat a hand shut-off valve and strainer be used on the incoming

supply line. A 1/4

outside diameter compression tube f itting is provided at t he back of the unit for the wa-

ter supply hook up (See Figure 1). For proper operat ion, the incoming water supply pressure m ust be in the

range of 30--90 PSI G. Install a pressure regulating valve if above this range.

1 2 3 4 5 6 7 8 9 10 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Cornelius SID650W/80-BC Manuel de l'opérateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Les fabricants de glaçons Cornelius SID650W/80-BC