Cornelius REMCOR R-134A Manuel d'utilisateur télécharger pdf (Page 39)

312027000 34

Item

No. Part No. Name

1 5470E Flat Washer

2 312418000 Ball Seat (Quad Ring)

3 312419000 Ball

4 5470D Spring

FIGURE 10. LIQUID CHECK VALVE ASSEMBLY

NOTE: When indicator on the CO

cylinder primary CO

regulator assembly 1800-psi gage is in the

shaded (‘‘change CO

cylinder’ ’) portion of the dial, the CO

cylinder is almost empty and should be

changed.

1. Fully close (clockwise) the CO

cylinder main shutoff valve.

2. Slowly loosen primary the CO

regulator assembly coupling nut allowing CO

pressure to escape, then

remove the regulator assembly from the empty CO

cylinder.

3. Unfasten safety chain and remove the empty CO

cylinder.

WARNING: To avoid personal injury and/or property damage, always secure the CO

cylinder in an upright position with a safety chain to prevent it from falling over. Should the

valve become accidentally damaged or broken off, the CO

cylinder can cause serious

personal injury.

4. Position full CO

cylinder in an upright position and secure with a safety chain.

5. Make sure a gasket is in place inside the primary CO

regulator coupling nut, then install regulator on the

cylinder.

6. Open (counterclockwise) the CO

cylinder main shutoff valve slightly to allow the lines to slowly fill with

gas, then open the valve fully to back-seat the valve. (Back-seating the valve prevents leakage around the

valve shaft).

7. Check all CO

connections for leaks. Tighten any loose connections and repair any leaks.

REPLENISHING SYRUP SUPPLY

NOTE: The following instructions are applicable only when replenishing same flavor syrup. Refer to

SYRUP FLAVOR CHANGE when changing syrup flavor.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

Cornelius REMCOR R-134A Manuel d'utilisateur Page 39

Commentaires sur ces manuels

Produits connexes et manuels pour Les fabricants de glaçons Cornelius REMCOR R-134A