Cornelius 500-Series Informations techniques télécharger pdf (Page 13)

Cornelius Ice Makers Training Manual

Extruder & Evaporator

The extruding head bushing is replacable. It is a special bushing that contains no lead, and needs to be

pressed into the shaft. The thrust bearings will become worn and should be replaced annually or as

needed.

FIGURE 4

The seal between the transmission and the evaporator should be replaced when necessary.

FIGURE 5

NOTE: Instructor to pain to manual reset overload location.

Nylon & Delrin thrust

bearings

Extruding head

Extruding

head bushing

Auger Nut

Auger

Transmission

Seal

Evaporator

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Pas de commentaire

Cornelius 500-Series Informations techniques Page 13