Cornelius 1000-Series Manuel de service télécharger pdf (Page 23)

Continuous Flow Icemaker Service Manual

Figure 17.

2. When the auger is lowered into the evaporator, rotate the auger to engage the motor drive shaft, see Figure 18.

Figure 18.

3. Carefully rotate the extruder head until the tabs on the extruder head drop into the slots on the evaporator

plate, as shown in Figure 19. When the auger/extruder head assembly is rotated to the proper position, it will

drop about 1/4 inch to more fully engage the motor drive shaft.

NOTE: Not all the tabs are the same width. Therefore, you must rotate the auger until all the tabs

are properly aligned with the evaporator slots. This may require almost a complete rotation

of the extruder head to complete.

CAUTION:

Keep hands out of the way when rotating the extruder head. When the auger is aligned, it drops down quickly and a

finger may be pinched due to the weight of the auger/extruder head assembly.

Auger/

Extruder

Head

Extruder

Evaporator

Head

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Cornelius 1000-Series Manuel de service Page 23